Do you have ISTA? If you do, run the test plans associated with your codes. It might suggest to run either or both of the Valvetronic Servomotor service functions:
1. Learn End Stops
2. Running-in Phase
I'd also recheck the following:
1. Check ALL injector connectors (dual white wires) for proper connector seating
2. Check ALL coil connectors for properly seating
3. Check ALL coils for complete seating with the spark plugs
4. Check ALL 3 grounds on the injector/coil harness (8mm nut)
5. Clear codes
Post your results again......
|