Ha; thanks for chiming in!
Was going to say I think that's the LCI housing, but I went to realoem.com and see same diagram for my VIN.
Not sure if realoem.com uses the same diagram for both, but from that shown, it's getting stuck where Part 5 and 1 meet, as if 5 may not be clipped into 1 properly.
But 5 on my car doesn't seem to have such clips, and my driver's seat 5 flexes in the same way my passenger seat does; just enough so the cord gets caught like 20% of the time. :|
Unless, there's clips only on the outer side of same and none on the inner, which is where I'm complaining of, and it's getting stuck between 5 and 4!
Looks like I'm going to need to take a picture for this one.
Will do so when I get my car back.
Thanks again.
BTW, currently at dealer for transfer gearbox replacement for the FOURTH time.
|