|
No luck. I bought an ODBLink CX and Bimmerlink. I had a number of codes including some misfires I'm not sure I should be concerned about. I deleted all of the codes it would let me, some codes it wouldn't or couldn't at least. There were no permanent codes.
The interesting thing is, is you can create a dashboard for sensors, and I threw a few of them up on the dashboard including "Raw value oil level" and the value I was getting would change based on my driving which seems to indicate the oil level is being monitored by what I can only assume is the oil level sensor. Perhaps driving around more after the errors would cleared will help. I'm not super confident.
I'm going to remove the pan later today and get some eyes on the sensor. A few videos I've seen show it soaked in oil, even though it wasn't dripping to the floor. Perhaps an oil soaked connector would cause this. Otherwise I've no clue what else to do other than buy a new sensor.
|