|
03-21-2024, 08:11 PM | #2 |
Captain
730
Rep 979
Posts |
This is actually an interesting question:
The Axle P/Ns are not the same:
But assuming everything equal except length...you'd think 1mm difference (607mm vs 606mm) on the left front axle shafts between the two part numbers would be within the tolerance of the CV joint tolerance, plus the shaft/lock-ring engagement to the differential. So these are within "1mm" of being interchangeable. That difference is 0.27" on the right front axles, which would matter, and that would be too much of a disparity to allow a high confidence of interchangeability. A 906mm shaft length would most likely not lock into the differential that requires a 913mm shaft length, and may not stay locked in when the wheels are turned full left or right. I wouldn't trust interchanging the right front shafts between chassis. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|